Cibolo Garage Floors

Cibolo · Schertz · Converse · Northeast San Antonio

Garage floors you can hose off — in about a day

Polyaspartic flake and epoxy garage floor coatings for Cibolo, Schertz, Converse and the communities around them. The slab is diamond-ground and repaired first, so the coating bonds instead of peeling — and most two-car garages are done in a single day.

01 — The short version

A coating is only as good as the grind under it

Garage floor coatings fail for one reason far more than any other: the concrete was not prepared. A floor that is only washed, or etched with acid from a hardware-store kit, gives the coating nothing to grip. Hot tires then pull it up in patches within a summer or two — the familiar "peeling epoxy" look.

A professional system starts with diamond grinding the slab to open the pores, repairing cracks and spalls, and only then applying a base coat, the decorative flake, and a clear topcoat. In a typical two-car garage that is usually a one-day job with a polyaspartic system, and you can walk on it the same evening.

02 — Finishes

Finishes & options

These images illustrate finishes and the effect of preparation. They are not photographs of specific local projects.

Full-broadcast flake

Best for everyday two-car garages

The most requested garage finish. Hides dust and tire marks, adds grip, and is the easiest to keep looking clean.

Before & after

What proper preparation changes

Oil stains, hairline cracks and dusting concrete are ground, repaired and sealed under the coating — the prep is the job.

Metallic epoxy

Best where looks come first

A poured, marbled look for shops, man caves and showrooms. More slippery than flake and less forgiving of dust.

How a polyaspartic garage floor is installed →

03 — How it works

From call to parked car

  1. 01

    You call or send the garage size, the city and a couple of photos of the floor

  2. 02

    An installer looks at the slab, checks moisture and existing coatings, and gives you a written estimate

  3. 03

    On install day the floor is diamond-ground, vacuumed, and every crack and pit is filled

  4. 04

    Base coat, full flake broadcast, scrape and vacuum, then a clear polyaspartic topcoat

  5. 05

    Walk on it that evening; park on it once the installer gives the go-ahead, usually after about 24 hours

04 — What to ask any installer

“Do you grind the floor or acid-etch it? Is the topcoat polyaspartic or polyurethane? And what exactly does the warranty cover — peeling, or just fading?”

Three questions that separate a real system from a kit

Why so many garage floors peel around here

Drive through any subdivision in Cibolo or Converse with the garage doors open and you will see it: coatings lifting in two neat stripes where the tires sit. Almost always, that floor was coated from a kit without grinding, and a few Texas summers of hot tires were enough to pull it up.

The fix is not a better kit. It is preparation — diamond grinding to open the concrete, proper crack repair, and a professional multi-coat system with a topcoat built for heat and UV. That is the only kind of floor we talk about on this site.

What decides the price

Square footage matters, but condition matters more. A clean, newer slab is the simplest case. Oil-soaked concrete, wide cracks, spalling near the door, and especially an old coating or paint that has to be ground off all add time. That is why an honest estimate comes after someone has seen the floor, and why two garages of the same size can be priced quite differently.

When you call, it helps to have the garage size (1, 2 or 3 cars), the city, and a couple of daylight photos of the floor. That is enough to get the conversation started.

Service area

Where we work

Cibolo and the ring of communities around it — from Schertz and Converse to New Braunfels, Seguin and the Hill Country edge. Each has its own page.

Questions

Frequently asked

How much does a garage floor coating cost in Cibolo?

It depends on size and condition. Most two-car garages land in the low-to-mid thousands of dollars; old coatings, heavy oil contamination or major crack repair add cost. You get a written estimate after the floor has been seen.

How long does it take?

A typical two-car garage with a polyaspartic system is usually done in one day. You can walk on it that evening and park after about 24 hours.

What is the difference between epoxy and polyaspartic?

Epoxy builds thickness and bonds well but can yellow in sunlight and cures slowly. Polyaspartic cures fast, resists UV and hot tires, and is usually the better topcoat for Texas garages. Many systems use both.

Will the coating hide cracks?

Existing cracks are repaired and coated over so they do not show, but the clay soil around Cibolo keeps moving and new hairline cracks can appear over the years.

Which areas do you cover?

Cibolo, Schertz, Converse, Universal City, Selma, Garden Ridge, Live Oak, Marion, New Braunfels, Seguin, Kirby, Windcrest, Bulverde, St. Hedwig and Timberwood Park.

Is the estimate free?

Yes. Looking at the floor and giving you a written estimate costs nothing and carries no obligation.

Ready for a floor you can hose off?

Tell us the garage size and the city · free estimate · no obligation

✉️ Get a Free Quote Call